Based on the tried and true design of the JK Premium Front Bumper, the stylish stamped steel face of the new JK Tubeless Front Bumper is built to withstand all the rocks, mud and brush you can throw at it while providing a clean, European look. With full vehicle width and an optional Skid Plate, you get the best front-end protection in the industry with a design that melds seamlessly with your JK Wrangler. The heavy-duty chassis mounted tow points and an optional Winch Mount will help you out of sticky situations, and you'll look good doing it. The JK Tubeless Front Bumper includes auxiliary light mounts, factory fog light mounts, chassis-mounted tow-points and crush cans. It also receives an OE-level double stage paint process to help keep Mother Nature at bay.
Add accessory power that's ignition switched to operate accessories such as CB radios, radar detectors, portable GPS, iPod, satellite radio, auxiliary lighting and more. The JK uses a CANbus system consisting of multiple micro-controllers needed to communicate with each other. The only switched ignition lead available to tap into is located behind the lower dash power port. This is the only place that a switched accessory can safely be attached. This is an easy way to add accessories without causing damage to the electrical system. The kit allows you to neatly wire accessories that are switched on and off with the ignition key. Made in USA exclusively for Quadratec.
The Flashpaq programmer optimizes Jeep engine settings to maximize performance with the throttle body and CAI installed. Superchips' 62mm bore high-flow throttle body accommodates increased airflow and improves overall drivability. Fresh air enters through the TrailJammer EXT's cold-air intake, which flows 97% better than stock: 195 CFM compared to the OE 99 CFM. The system's oil-impregnated, cotton-mesh filter traps dirt and debris and is washable/reusable.
Organize and see at a single glance all of your necessities for the day! This new Organizer from Vertically Driven Products zips open to expose four separate compartments with clear windows. It features outside mesh pockets for easy access to your cell phone without opening bag. Made from Armor tough Ballistic Nylon with 1/4" thick foam lining and plastic end caps this organizer is weather and Shock resistant. Snaps on or off wherever you install the mounting straps. Mounts to anything .25 up to 4" diameter roll bars, handle bars, etc. Buy several and keep them pre packed for everyday use, off roading, fishing, hunting, camping, biking, golfing, boating, beach, over night bag, cosmetics, travel, etc. Buy a pair of VDP Organizers and save!
For those looking to equip their vehicle for serious rock crawling, WARN now offers a narrower version of the popular Rock Crawler Bumper. Laser-cut and CNC-formed for durability, these bumpers have eyelets for D-shackles and recessed mounting hardware for a clean finish and reduced fastener corrosion. All bumpers includes a winch mount that accepts all WARN mid-frame winches 12,000 lbs. capacity and under (excluding M8274-50 winch*).
WORLD CLASS WARN PERFORMANCE AT A VERY COMPETITIVE PRICE. WARN's new popular VR Series Winches just got a lot more attractive! Introducing the new VR8000-S and VR10000-S winches with new Spydura Synthetic Rope. You get the same great VR Series winch but now wrapped from the factory with synthetic rope and polished aluminum hawse fairlead. All at a great low price! For those who demand a little more from their winch, the new CTI-S Contactor Equipped Winch with Synthetic Rope is the answer.
The NEW Factory Performance Series OE Replacement Shocks from Fox Racing Shox are performance tuned for the specific application using deflective disc technology. The High pressure nitrogen gas charged shock features and Internal Floating Piston which separates the air from oil for fade free performance, improved ride, handling and control. Features include Precision Machined Anodized Shock ends, 47mm Mono-tube Shock Body made from Forged Aluminum which dissipates heat faster for reduced shock fade and a Heavy Duty Hard Chrome Polished 5/8" diameter shock shaft.
RotopaX are the only EPA and CARB compliant fuel containers available for sale in the United States! This is thanks to a patented three layer Roto-Molding process, along with specially formulated plastic barrier material to meet the governments new extremely low permeability requirements. RotopaX (patent pending) are proudly made in the USA by the original manufacturer of the 1st generation fuel and water packs. RotopaX are Rotational Molded - the process which produces indisputably superior products. Choose which container fits your needs. The interlocking design allows you to mix and match for the ultimate set up!
Jeep Parts & Jeep Accessories Take your Jeep to the next level with the parts found on our site. We are a leading Jeep accessories retailer, providing performance products for our customers. We work hard to give you the best information to turn your vehicle into a top-notch ride. Whether you are looking for 4wd suspension parts & accessories or want improved Jeep performance, we have the parts & Jeep accessories you need.
The terms Quadratec and Essentials are Registered Trademarks of Quadratec Incorporated, Registered in U.S. Patent and Trademark Office. All manufacturers names, numbers, symbols and descriptions are used for reference purposes only, and it is not implied that any part listed is the product of these manufacturers or approved by any of these manufacturers.
*Jeep, Wrangler, Rubicon, Renegade, CJ, Quadra-Trac and the Jeep Grille Design are registered trademarks of Chrysler LLC. Quadratec, Inc, has no affiliation with Chrysler LLC. Throughout this website and catalog the terms Jeep, Wrangler, MOPAR®, & Rubicon are used for identification purposes only. Geo is a registered trademark and Tracker is a registered trademark of the General Motors Company. Sidekick and Samurai are trademarks of Suzuki Motor Corporation. Amigo is a product of Isuzu Motors Limited. Chevrolet, the Chevrolet Emblem, S Series, GMC, GMC Truck, Chevy, Vortec and Sonoma are registered trademarks of the General Motors Company. Expedition, F-Series, F-150, F-250, F-350, Super Duty and Flare Side are registered trademarks of the Ford Motor Company. All other marks, names, and logos mentioned on this web site are the property of their respective owners.
Throughout this web site all the preceding marks & logos are used for identification purposes only. Quadratec has no affiliation with the Chrysler LLC, MOPAR®, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited. It is not implied that any part listed is a product of, or approved by Chrysler LLC, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited.
Quadratec, Inc. is sometimes mis-searched as Quadartec and Quadratech, we have no affiliation with either.
