Skip to main content
Home » Jeep Driveline » Lockers » Limited Slip Differentials » EATON Trutrac Limited Slip Differential
« Back to product
Will it fit '18 JLU with 3:73 gears?
Eaton does not yet offer a Truetrac differential for JL Dana 35 M200 AdvanTEK. Thanks for your inquiry.
Can this be used to replace stock open carrier with stock axles on my 1989 YJ with Dana 35 . Will it accept 4.56 gears . Thank you
Yes, this application is correct for your Jeep's stock axles with an open diff. Be aware that 4.56 is not a direct fit ratio for your factory Dana 30 front Differential case if you had stock 3.73 or numerically lower gear ratio from factory. If you are unsure, we can try your vin number for confirmation at 800-745-6037. Thanks for your inquiry.
I have a 2002 Jeep tj se would this fit I believe it has a Dana 35 in the rear just wanna make sure this fits right in with out having to change out my stock front differential ratio ? Or messing anything up
If your original gear ratio is 3.21, you will need to change the from diff to one that can handle the carrier break of the higher gear ratios. https://www.quadratec.com/products/52410_10.htm. If you are not sure what ratio your Jeep has, call 800-745-5337 and we can check it for you. Thanks for your inquiry.
I have a 1988 jeep Cherokee Laredo with the dana 35C or custom will this work in it without a buch of modifications?
Yes, this will drop right in, Laredo should already have 3.55 ratio, just verify yours
will this work with 4.88 gears in my jeep cherokee xj 1993 standard
Yes, it will. Please verify that you have a Dana axle and not a Chrysler axle though.
I have dana 44 in my Jeep Tj with 4.88 gear. would work perfect with 488.? would I have to make any changes?
This is for a Dana 35 axle. You cannot use this in a Dana 44
Will I need special bearings and races for this?
No, you can use the factory style. Just be sure that they are properly shimmed before reinstallation.
I have a 91 YJ with a trac lok. Will this fit in my carrier?
Yes this could replace your trac-lok, the factory gear ratios for that axle were 3.55's and 4.10's, so you should at least have the base gearing to handle this.
will this work with 4.88 gears
Yes
Will this work with 3.73 gears?
Yes it will. 3.55, 3.73, 4.10, 4.28 and 4.56 gears will fit this locker