JKS Manufacturing J-Axis Rear Control Arms for 07-18 Jeep Wrangler JK

JKS Control Arms utilize greasable brass bearings for smooth, reliable operation and excellent longevity. Fine pitch adjustment threads ensure superior strength and unsurpassed tuning ability. With over 3" of adjustment, the working length of each JKS Control Arm can be increased, decreased or exactly the same as the OE suspension arm.
Constructed of heavy-gauge steel tubing and MIG welded for quality and consistency, our Control Arms are much stronger and resistant to impact than the original suspension arms. New OE rubber bushings are used to isolate road noise and vibrations without over-stressing the mounting brackets. Finally, a durable powdercoat finish and zinc plating provide excellent corrosion protection.

Product Overview
A combination of upper and lower suspension arms position and control axle movement on most coil sprung Jeeps®.

The fixed-length OE suspension arms are bolted to the chassis and axle through rubber bushings to help reduce the transfer of noise into the vehicle. The rubber bushings also absorb torsional forces created by the suspension arms off-road.
Aftermarket suspension arms and bushings that are less flexible will over-stress the chassis and axle mounting brackets and should not be installed. Yet many manufacturers provide these components with their suspension kits to save money.
Product Features
Lubricated threads and internal brass bearing for smooth operation and excellent longevity
Spring-loaded, crankshaft type seal prevents moisture and debris contamination
Heavy duty construction is far stronger than the thin gauge stamped metal OE suspension arm
Threaded body utilizes superior 18 threads-per-inch versus inferior 5 threads-per-inch used by competitors
Durable powdercoat finish and zinc plating provide excellent protection from corrosion and debris

Installation Notes

Installation Difficulty:

Level 2Intermediate

Lower Control Arms adjust 1.0" shorter and 2.25" longer than OE suspension arms. Upper Control Arms adjust 0.25" shorter and 3.75" longer than OE suspension arms.

Installation Time: 1-2 hours

Installation
Instructions

Parts Included

Control Arm Pair

Warranty

Limited Lifetime Warranty