Passenger Side Tail Lamp
Drivers Side Tail Lamp
Jeep Wrangler (TJ)
- 1997 Jeep Wrangler (TJ)
Very easy to install on my 97 Sahara. The only exception to the install guide is that on the driver’s side housing you will have to unscrew the clear plastic piece containing the license plate light and lower it to screw in and tighten the two lower housing screws and then re-attach the clear piece, there is no room to get a socket on the screw while this clear piece is in place.
The other exception is on the passenger side light, because the Cyclops light is a part of that wiring harness you cannot get the plug outside of the vehicle (the install guide mentions this possibility) so I secured the light housing to the rear without connecting the wires and they hung low enough to connect them from under the rear quarter panel.
Couldn't believe the amount of dirt that had accumulated behind my old lights.
Also the bracket holding the fuse under the dash panel is designed to fit into groves on the old fuse, the new one has no groves so using pliers I bent the tabs in the bracket out a little and zip tied the bracket to the new fuse so it could be reused with the screw holding it up under the dash.
So they are installed, they work, they're bright and they look good.