All Q Series Winches include two sets of solenoid brackets for side mounting or top mounting.
LL= Limited Lifetime Y= Year
*** Gear Reduction to 1, otherwise known as the "Gear Ratio". A higher numerically gear ratio will provide slower and more powerful pulling while also providing the least amount of amp draw on your battery because the winch motor doesn't need to try as hard. A lower numerically gear ratio will pull faster but also put more amp draw on your battery.
1 Hefty Clutch Control
2 Case Hardened Input Gears
3 Case Hardened Intermediate Gears
4 Case Hardened Output Gears
5 Stainless Steel Hardware Throughout
6 Case Hardened Hex Drive Shaft
7 Load Holding Brake System
8 Winch Drum is Case Hardened
9 High Strength Aluminum Tie Bars
10 Shaft Coupler is Case Hardened
11 Solid Copper and Brass Power Terminals
12 Durable Powder Coat Finish
13 Powerful 4.8 Horsepower Series Wound Motor
14 Heavy Duty Solenoid with 2 Bracket Locations
15 Galvanized Aircraft Cable 100' x 3/8"
16 Stainless Steel Safety Latch
17 Forged Steel Clevis Hook
18 Nylon Safety Hook Strap
19 High Visibility Rubberized Winch Remote with 12' Cord
20 Solid Copper Battery Cables
21 Zinc Plated Roller Fairlead
Zinc Plated Roller Fairlead
100' x 3/8" Aircraft Cable
Forged Steel Clevis Hook
Nylon Safety Hook Strap
12' Wire Remote Control
Remote Solenoid Box
Motor Mounted Solenoid Box Mount
Center Mounted Solenoid Box Mounts
1 Year Limited Warranty on Electrical Components.
- Line Length: 100 ft
- Line Pull: 9,000 lbs
- Max Line Speed: 19 ft/min
- Current Draw: 300 amps
- Remote: Wired
- Intended Usage: Occasional
- Solenoid: Remote
- Line Type: Steel Cable
Easy install. Unit looks of good quality. Hopefully never have to use but just in case, I have one that didn't cost a fortune.
Works great on my LJ. I can't speak for long-term reliability yet but it was able to pull me up a 50-degree incline through sand and snow when the KO2's couldn't find traction.
after a little over a year installed never used when I tried to use it , it did not work the harness to the solid state relay was defective it was inexpensive to replace but Reilly !!!