The ECTED is a selectable traction device; an on/off switch is mounted near the driver. When “off” – the clutch pack (7), which is located behind the side gear (6) provides the limited slip mode. As torque increases, the separating forces within the differential gears increase, causing the clutch pack to be compressed and thereby providing bias torque to the high traction wheel – your performance limited slip differential action. When selected “on”, current is sent to the electromagnetic coil (8). The coil is retained by a clip that fits over one of the bearing cap bolts, making it non-rotational. The coil rides on a ball bearing (9). The ball bearings spin with the differential case (10).
The coil creates a magnetic flux so that the pilot cone (1) is pulled into engagement with thedifferential case (10). This frictional engagement causes the bearing balls (2) to ride up on a ramp machined into the side gear (3). This radial travel of the balls (2) also causes lateral movement of the side gear (3). The lateral movement of the side gear (3) applies a force onto the center block (4). The center block (4) has an elongated hole that the center pin (5) fits through, allowing it to float. The center block (4) applies force to the opposite side gear (6), compressing the clutch pack (7) giving the user a solid axle assembly – the spool/locker performance you desire at the strip or off-road.
ECTED™ Advantages
ECTED gearing is made from aircraft quality, 9310 heat-treated billet steel to make it as tough as nails!
ECTED can be switched on or off “on the fly,” at any road speed.
ECTED does not have any shift forks or pins that must be lined up to obtain locker mode.
ECTED is quiet – say good-bye to noisy lockers!
ECTED is backed by an industry-leading one-year warranty, just like all Auburn Gear Performance Differentials.
ECTED can be used in front axle applications – with or without lockout hubs.
ECTED is the only selectable locker that offers both limited slip and locker modes. Forget the rest - go with the best!
Important Note: The ECTED is not recommended for use in front axles that feature an "Inter-Axle Disconnect".
In the product configurations offered, ECTED is the only selectable locker that offers both limited slip and locker modes.
Jeep Parts & Jeep Accessories Take your Jeep to the next level with the parts found on our site. We are a leading Jeep accessories retailer, providing performance products for our customers. We work hard to give you the best information to turn your vehicle into a top-notch ride. Whether you are looking for 4wd suspension parts & accessories or want improved Jeep performance, we have the parts & Jeep accessories you need.
The terms Quadratec and Essentials are Registered Trademarks of Quadratec Incorporated, Registered in U.S. Patent and Trademark Office. All manufacturers names, numbers, symbols and descriptions are used for reference purposes only, and it is not implied that any part listed is the product of these manufacturers or approved by any of these manufacturers.
*Jeep, Wrangler, Rubicon, Renegade, CJ, Quadra-Trac and the Jeep Grille Design are registered trademarks of Chrysler LLC. Quadratec, Inc, has no affiliation with Chrysler LLC. Throughout this website and catalog the terms Jeep, Wrangler, MOPAR®, & Rubicon are used for identification purposes only. Geo is a registered trademark and Tracker is a registered trademark of the General Motors Company. Sidekick and Samurai are trademarks of Suzuki Motor Corporation. Amigo is a product of Isuzu Motors Limited. Chevrolet, the Chevrolet Emblem, S Series, GMC, GMC Truck, Chevy, Vortec and Sonoma are registered trademarks of the General Motors Company. Expedition, F-Series, F-150, F-250, F-350, Super Duty and Flare Side are registered trademarks of the Ford Motor Company. All other marks, names, and logos mentioned on this web site are the property of their respective owners.
Throughout this web site all the preceding marks & logos are used for identification purposes only. Quadratec has no affiliation with the Chrysler LLC, MOPAR®, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited. It is not implied that any part listed is a product of, or approved by Chrysler LLC, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited.
Quadratec, Inc. is sometimes mis-searched as Quadartec and Quadratech, we have no affiliation with either. [2]
