Custom Rear Subwoofer Kit with 10" Kicker CompVR Subwoofer
For 87-95 Jeep® Wrangler YJ
Quadratec Part No: 14136.322 Manufacturer Part No: -SUB87-CVR $469.99
Premium sound that's engineered by our local expert audio team and ships within 48 hours! From hard rock to hip hop, jazz to bee bop, your music never sounded this good. And the bass is fully adjustable to your taste. Our subwoofer kits mount behind the rear seat and fasten to the floor using existing bolt holes. Subwoofer is wired at a 2ohm load for increased power. Assembled in USA.
Requires radio specific Subwoofer Wiring Kit for installation.
1200W Mono-Block MOSFET Amplifier, High/Low Crossover, with Remote Subwoofer Level Control
2 Ohm Stable Mono-Block
Variable low pass crossover: 40-150Hz
Fixed high pass crossover (200Hz)
Variable 0 to +18dB Bass Boost
Variable input gain control
Power and protection LED indicators
Thermal, overload and speaker short protection
Line and speaker level inputs
Chrome plated RCA connectors and screw terminals
Remote subwoofer level control
Frequency response: 9Hz - 50kHz (+/- 3dB)
Max power 2 ohm 1200W X 1
RMS power 4 ohm 500W X 1
Signal-to-noise ratio 103dB
THD at RMS output 0.01%
Damping factor 125+
Dimensions (9-1/8" L x 10" W x 2-7/16" H)
Kicker CompVR 10" Subwoofer
The CompVR takes superlative KICKER woofer technology and pounds it into a cutting-edge, bass machine for this year and beyond.
With know-how dating back to the legendary KICKER Competition Subwoofer, the CompVR’s newest upgrades perform at a threat level Homeland Security can’t even classify. CompVR’s dual voice coil and overall motor structure has been beefed up altogether – it’s able to take more heat, more abuse, and more power. The same high-temperature wire used in premium Solo-Baric voice coils has been used here. The motor’s top plate has taken on a more efficient design too, among other improvements.
A ribbed Santoprene® surround attaches this amazing motor to an injection-molded cone that refuses to die. Distortion in the cone is totally eliminated with new back bracing and an aluminized coating.
The tough look will turn your compadres’ heads. The silver-coated, stamped-steel basket is surrounded by a sharp logo trim piece that serves a dual purpose – it strengthens the surround completely while making an edgy design statement. Spring-loaded push terminals and perimeter venting are only a couple of KICKER standards that finish the picture. And the 10-inch CompVR is primed for an afternoon at sea or on the lake with its powder coating and stainless-steel hardware.
Jeep Parts & Jeep Accessories Take your Jeep to the next level with the parts found on our site. We are a leading Jeep accessories retailer, providing performance products for our customers. We work hard to give you the best information to turn your vehicle into a top-notch ride. Whether you are looking for 4wd suspension parts & accessories or want improved Jeep performance, we have the parts & Jeep accessories you need.
The terms Quadratec and Essentials are Registered Trademarks of Quadratec Incorporated, Registered in U.S. Patent and Trademark Office. All manufacturers names, numbers, symbols and descriptions are used for reference purposes only, and it is not implied that any part listed is the product of these manufacturers or approved by any of these manufacturers.
*Jeep, Wrangler, Rubicon, Renegade, CJ, Quadra-Trac and the Jeep Grille Design are registered trademarks of Chrysler LLC. Quadratec, Inc, has no affiliation with Chrysler LLC. Throughout this website and catalog the terms Jeep, Wrangler, MOPAR®, & Rubicon are used for identification purposes only. Geo is a registered trademark and Tracker is a registered trademark of the General Motors Company. Sidekick and Samurai are trademarks of Suzuki Motor Corporation. Amigo is a product of Isuzu Motors Limited. Chevrolet, the Chevrolet Emblem, S Series, GMC, GMC Truck, Chevy, Vortec and Sonoma are registered trademarks of the General Motors Company. Expedition, F-Series, F-150, F-250, F-350, Super Duty and Flare Side are registered trademarks of the Ford Motor Company. All other marks, names, and logos mentioned on this web site are the property of their respective owners.
Throughout this web site all the preceding marks & logos are used for identification purposes only. Quadratec has no affiliation with the Chrysler LLC, MOPAR®, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited. It is not implied that any part listed is a product of, or approved by Chrysler LLC, General Motors Company, Ford Motor Company, Suzuki Motor Corporation or Isuzu Motors Limited.
Quadratec, Inc. is sometimes mis-searched as Quadartec and Quadratech, we have no affiliation with either.
