« Back to product
Loren W.
Can I use the existing fasteners to install?

For the safest and most reliable installation, it is highly recommended to use the new mounting hardware that is included with the Crown Automotive BELT1B seat belt kit. This ensures proper fitment and maintains the integrity of the safety system.
If your existing fasteners are in absolutely perfect, like-new condition and you are certain they are the exact same type and size as the new ones, you might be able to reuse some. However, without a direct comparison and confirmation, it's best to err on the side of caution and use the provided hardware.
If your existing fasteners are in absolutely perfect, like-new condition and you are certain they are the exact same type and size as the new ones, you might be able to reuse some. However, without a direct comparison and confirmation, it's best to err on the side of caution and use the provided hardware.
Mike M.
Can I use the female section to connect my existing rear shoulder harness?

No. It will not receive the original seat belts It is not sized correctly. 55029708 is the OE part number for the buckle section. Sorry for the inconvenience. Thanks for your inquiry.
Randall M.
Do I have to drop the fuel cell to install seat belts on my CJ7

Dropping the tank would make access to the underside easier, but it is not required. It will be tight
Randall S.
Is the female strap long enough to go through the back of the seat? It appears, I will have to purchase these for the female end and then purchase a set of three point belts in order to do a complete rear seat replacement.

Yes the buckle end is long enough to reach through the gap in the bench seat.
JAMES S.
How long is the female receiver end?

The receiver end is approximately 9" from center of eye to end of buckle
Michael W.
This is a single belt. I would need this twice for two passengers?

Yes that is correct.
John C.
There is a bracket that holds both female receivers on the rear seat belt . Is this available ?

The bracket that held the two straps at one point is not longer available. That was a factory part serviced only with the belts. In this case you will have to stack the two brackets.