« Back to product
Bob S.
Will they be long enough for a 2” spacer ?
No, the Crown Automotive RT32017 wheel stud is not long enough to go through or replace studs for a 2-inch wheel spacer.
Key Specifications of Crown RT32017:
• Total / Under-Head Length: Measures approximately 1.688 inches (11/16") from under the head.
• Thread Length: Approximately 1.1 inches.
• Thread Size: 1/2"-20.
• Purpose: This part is a direct-fit replacement stud designed to be pressed into specific RT Off-Road / Crown aluminum wheel spacers or select Jeep hub applications (typically for thinner 1.5-inch spacer kits or factory replacements).
Key Specifications of Crown RT32017:
• Total / Under-Head Length: Measures approximately 1.688 inches (11/16") from under the head.
• Thread Length: Approximately 1.1 inches.
• Thread Size: 1/2"-20.
• Purpose: This part is a direct-fit replacement stud designed to be pressed into specific RT Off-Road / Crown aluminum wheel spacers or select Jeep hub applications (typically for thinner 1.5-inch spacer kits or factory replacements).
JAIME JAVIER G.
Cual es el codigo de la tuerca?
This is for 1/2-20 standard lug nuts.
Jason P.
Are they a direct replacement for the factory rear wheel studs?
No, these are not for the axle hubs. Please see 68398367AA
Jason P.
Are they replacement for the rear axle or the the spacer?
These are replacements for the studs that are pressed into the aluminum spacer itself
Byron S.
Will these work for a 1.5" wheel spacer, the rear studs are shorter than the front studs
Yes, the Rough Trail Spacers that these are used on are 1.5"