« Back to product
Eugene P.
Steps close hard is their an adjustment?
No, there is no mechanical adjustment for how hard the steps close.
The Rock Slide Engineering Gen III Step Sliders rely on a pre-programmed electronic control module and internal motor stops. If a step is slamming or closing abruptly, it is usually caused by one of a few common issues:
Binding Linkages: Check the pivot points and linkages for grit, mud, or debris buildup that can restrict smooth movement.
Lubrication: Applying a dry PTFE or silicone lubricant to the pivot pins can free up any resistance causing jerky or hard closures.
Power Supply: Weak battery voltage or a poor ground can cause the motors to behave erratically.
The Rock Slide Engineering Gen III Step Sliders rely on a pre-programmed electronic control module and internal motor stops. If a step is slamming or closing abruptly, it is usually caused by one of a few common issues:
Binding Linkages: Check the pivot points and linkages for grit, mud, or debris buildup that can restrict smooth movement.
Lubrication: Applying a dry PTFE or silicone lubricant to the pivot pins can free up any resistance causing jerky or hard closures.
Power Supply: Weak battery voltage or a poor ground can cause the motors to behave erratically.
Michael C.
does this fit 2026 Jeep Wrangler Rubicon x with the factory frame mount crash bracket?
Yes, the Rock Slide Engineering Gen III Step Sliders will fit a 2026 Jeep Wrangler Rubicon X, but because the step sliders mount directly to the factory body mount locations along the pinch seam and frame, you may need to navigate the factory front anti-intrusion / frame crash brackets located near the front wheel wells.
On newer JL models equipped with these factory frame-mounted crash brackets, some owners find that the bracket sits closely or interferes with the front leg/bracket of aftermarket step sliders. If there is any contact during installation, it can typically be cleared by slightly trimming/notching the inner bracket or adjusting the slider placement, after which it bolts right up securely without compromising the step's operation or structural integrity.
On newer JL models equipped with these factory frame-mounted crash brackets, some owners find that the bracket sits closely or interferes with the front leg/bracket of aftermarket step sliders. If there is any contact during installation, it can typically be cleared by slightly trimming/notching the inner bracket or adjusting the slider placement, after which it bolts right up securely without compromising the step's operation or structural integrity.
Michael C.
I have a 2026 wrangler JL and it seems that Jeep has added a crash bracket to the front frame area. I could not install the AMP or rough country power steps unless I remove that crash bar. I don’t want to remove crash bars, will yours work with this setup?
Yes, the Rock Slide Engineering Gen III Step Sliders will work without having to remove your factory crash bars.
Unlike other power steps that conflict directly with the newer frame-mounted brackets on 2026 models, the Gen III sliders utilize a body-mount bracket system along the pinch seam. If there is any minor proximity contact near the front leg, it can be easily cleared with a slight adjustment or minor trim of the inner plastic/bracket without needing to strip off the factory crash structure.
Unlike other power steps that conflict directly with the newer frame-mounted brackets on 2026 models, the Gen III sliders utilize a body-mount bracket system along the pinch seam. If there is any minor proximity contact near the front leg, it can be easily cleared with a slight adjustment or minor trim of the inner plastic/bracket without needing to strip off the factory crash structure.
Bradley H.
How far down does the step extend?
The step will deploy a full 12 inches down from the body of the Slider when the door is opened.
Chuck S.
Will the RSE Step Sliders fit on a 2024 Rubicon 4xe
Yes they will!
Scott T.
These deploy when you open the door. How about when you have the doors off?
You'll want to install the doors off kit. Rock Slide Engineering SL-DD-100 Door Delete Kit for All Jeeps with RSE Step Sliders
Tamara R.
Do these fit a 2023 Rubicon 392?
Yes, they do.
KENNETH B.
Will these fit on a 2024 4 door Rubicon? If I take the rock rail off?
Yes, they will when you have removed the factory equipped rock rails. Thanks for your inquiry.
Tim W.
Your notes say that it doesn’t fits a Willy’s model can you tell me why
The factory equipped rock rails would need to be removed. Thanks for your inquiry.
Erik H.
Seems like yes, but want to make sure before spending the $ on these, but they're compatible with the 2023 4xe Rubicon correct?
Yes, as long as the Rubicon rock rail is removed prior to installation of the RSE Step Sliders. Thanks for your inquiry.