« Back to product
Dan F.
Are these direct plug and play? Does a 2023 JL need to be reprogrammed when switching from halogen to LED?
The DV8 Offroad HLCJL-02 LED Headlights are designed as a direct plug-and-play installation for factory halogen setups, typically taking under an hour to install.
However, for a 2023 Jeep Wrangler JL switching from factory halogens to LEDs, reprogramming (flashing) the Jeep's computer is required. If you do not update the body control module (BCM) configuration to indicate that LEDs are installed, you may experience issues such as flickering, bulb-out warning messages, or improper high/low beam operation due to the lower electrical draw of LEDs compared to standard halogen bulbs. This can be done using a dealership scan tool or an aftermarket programmer like a SuperChip or Tazer.
However, for a 2023 Jeep Wrangler JL switching from factory halogens to LEDs, reprogramming (flashing) the Jeep's computer is required. If you do not update the body control module (BCM) configuration to indicate that LEDs are installed, you may experience issues such as flickering, bulb-out warning messages, or improper high/low beam operation due to the lower electrical draw of LEDs compared to standard halogen bulbs. This can be done using a dealership scan tool or an aftermarket programmer like a SuperChip or Tazer.
Travis H.
Direct replacement for halogen without any modifications? Will it need any kind of reprogramming to accept the led's?
Yes, they are a direct plug-and-play replacement for the factory halogens and plug straight into the existing factory harness without cutting or modifying wires.
Because these headlights feature a built-in anti-flicker canbus system designed specifically for the JL wiring architecture, no software reprogramming or Tazer configuration is required to prevent flickering or error codes.
To verify success after installation, simply turn on your headlights and high beams to confirm steady, flicker-free illumination with no dashboard warning lights.
Because these headlights feature a built-in anti-flicker canbus system designed specifically for the JL wiring architecture, no software reprogramming or Tazer configuration is required to prevent flickering or error codes.
To verify success after installation, simply turn on your headlights and high beams to confirm steady, flicker-free illumination with no dashboard warning lights.
Jason M.
Do these headlights have SAE/DOT markings on them?
Yes, they do.
David P.
Is this a pair of headlights or a single headlight?
This is for a pair of headlights.