« Back to product
Felix B.
What gauge steel is your carnivore winch mounting plate for plastic bumper made from ? I see 16gauge (1/16”) on a marketing flyer on the website. This must be a mistake.
Winch Plate is 5mm Carbon Steel (approximately between 6-gauge and 7-gauge)
Joseph F.
DOES THIS FIT THE 2025 JEEP WILLY'S WITH THE PREMIUM FRONT BUMPER WITH GLOSS-BLACK ACCENTS?
Yes, it will.
Angelo G.
What type of winch will it accommodate
Supports winches with the common 10" x 4.5" bottom bolt pattern.
Hamilton R.
Does this fit a 2022 Gladiator Rubicon automatic transmission? Looking to install a Badlands Apex 12000. Thanks!
Yes, it does.
Bobby K.
So the Plate will Replace the Tow Hooks right?
Correct, you'll replace the OEM tow hooks.
Jerry L.
Will this work with a JLU 2023 plastic bumper?
No, these are for the factory steel bumper only.
Ronaldo C.
I have a 2023 JT, steel stubby bumper with bull bar (Mopar). Planning to get OVS SCAR 12S winch. Will this mounting plate fit my setup?
Yes, it will. Thank you for your inquiry.
Matthew W.
Will this work with a Badlands Apex winch?
Yes, it will.
Guillermo G.
Is your monut compatible with the Smittybilt X2O Gen2 10K Waterproof 10,000 lb. Winch?
Yes, it is.
Lance L.
Is there suppose to be an angle to it? First one I got was angled upwards towards the vehicle when aligned with the front bumper holes. The side holes did not align to their respective due to this. This would also make the winch not sit level. I called and you guys were awesome in shipping another one but it is the same....2020 Rubicon Gladiator.
Yes, the angle is correct and there to make sure that all winches clear the front grille. Also, there are proper supports underneath and frame tie in points. Thanks for your inquiry.