« Back to product
Michael C.
can these be connected to the back up light circuit
They could be; cutting and splicing may be required, however.
Ed B.
I have the Carnivore rear bumper where you can install these lights. If I am going to get these to use as additional backup lights (wired to the reverse lights) should I get the flood beam or spot beam cubes?
Flood beams would illuminate the entire area around the back of the vehicle. The spot projects a single beam in the distance. For a reverse light, a flood light is a better choice.
Joseph B.
How big are the posts on the lights, 8mm or 10mm?
That is an 8mm bolt. Thank you for the question.
John H.
can these cubes be mounted underneath my bumper? that is to say, upside down?
If you have a threaded provision in a location where downward mounting won't cause a potential clearance issue, sure they can be mounted whichever direction you wish. Thanks for your inquiry.
Frank S.
I have a 2020 Wrangler JL and I want to mount these to the hood near the windshield - what brackets would you recommend?
The following bracket pair will allow the mounting of this light pair. See the following link for our part number 12110-9050 Windshield Light Mount Brackets for JL . Thanks for your inquiry.
Brad K.
Should a lighted switch be lit when the lights are on and off when the lights are off?
Yes, they should, when used with the equipped switch, relay, and wiring harness. Thanks for your inquiry.
George G.
What are the dimensions of this light.97109-1062
3-1/4" W x 3" H x 3-1/8 D . Optics are 2x2. Thank you for the question.
Cheryl H.
Is the included wiring long enough to reach the rear bumper? Can this be installed in the cutouts of a bumper
The included wiring harness leads measure 72" and 120".
Todd G.
How would I extend the wiring harness to put the lights in a rear bumper
You can use the Quadratec back up lighting harness. 97109 0924 is the part number.
George M.
Is there an amber lens cover option for this model?
There is not at this time.