Reviews for Carnivore 3" Cube LED with Wiring Harness & Windshield Mounting Brackets for 07-18 Jeep Wrangler JK

Style

Another quality kit. Well packaged and quick delivery as always. Took about 2 hours to install as you have to remove some of the dash to get to the cigarette lighter. That was the hardest part. But they are very bright and look as good or better than a higher priced set. Make sure to order the longer a-pillar bolts. That is the only negative.

Awesome...

went on super easy. actually had lights completely installed and wired up in 45 minutes. the hardest part is just pulling the wires thru the firewall

Perfect kit. Straight forward and easy install. No adjustments needed for the tilt and stock bolts are long enough to use w the mounting brackets.

Installed pretty easy, but one bolt on the passenger side wasn't going in. I shaved off some of the pad then it went in fine.

Easy to install work great

This says it all. Great package at this cost. Comes with everything, including way more cable length to the lights than needed for lower windshield mounting. Nice to have it if you decide to move lights later to the grill or back of the Jeep. Had no issue using the factory screws for the brackets, even comes with a 40T Torx wrench (if running light wires to the engine compartment by lifting up the center factory piece, between the two cowls, you'll need a 30T Torx bit which is not included). Lights are bright. Great package at this price. Very happy with these light, better then I expedited. Photos don't do them justice.

These cube lights are just what I was looking for. Easy fit and install.

Lights work great, I got floods but might want to get some spots also, brackets work well and the wiring harness made it all easy.