Question 1

RICHARD B.

9/20/2022

Installed heavy winch bumper with winch...will this take the droop out of my front end? and should I install the .75" spring spacer to help with factory rack angle?

Answer

Yes, the use of an added spacer as long as it is .75" or smaller in height should be okay for helping to offset some of the droop in front from added weight. Thanks for your inquiry.

Question 2

Frank T.

1/9/2022

I want to install the air lift 1000 air bags with the TF 2.5” spring lift. The lift kit comes with spring retainers for the rear in which the bolt fills the hole where the air bag hose is supposed to run through. It seems like I have two possibilities. One is to run the hose out of the top, thereby installing the air bags upside down from instructions. Not sure why this wouldn’t work. The other would be not using the spring retainers and installing the bags as per the instructions. Thoughts?

Answer

Take this into consideration while driving. Do not add, alter or fabricate any factory or aftermarket parts to increase vehicle height over the intended height of the Tera Manufacturing product purchased. Mixing component brand is not recommended. Thanks for your inquiry.

Question 3

Tanner B.

11/23/2021

Is there a need for exhaust brackets for this Lift kit?

Answer

They are not required with a 2.5" lift. Any larger, they should be used. Thanks for your inquiry.

Question 4

David P.

11/3/2021

Will I need to purchase wheel spacers for this kit?

Answer

If using with factory wheels, offset adapters will be required. Thanks for your inquiry.

Question 5

Wes P.

12/22/2020

I have a 2013 JKUR w/ 71k miles. I am looking for a lift kit and I came across the Teraflex Part #: 1352000 and was curios if I shopped get the kit with shock adapters or get shocks since I have a few miles on my rubicon. I plan on running stock wheels as well. Will this be the right kit for me? will I need a new driveshaft because I was also looking at the mopar 2". Thanks for your help.

Answer

This kit will work fine with your stock shocks using the "Adapter" option, when it is time to replace your shocks down the line you have the option of removing the adapters and getting extended shocks which will expand your options. You do not need to go the route of the driveshaft if you get the exhaust spacers 2610000. That option saves money. The only reason to change shafts is if you are looking to upgrade from the CV to the U-joint style shaft.