« Back to product
FRANCISCO M.
Compatible replacement for Teraflex Heavy Duty?
Yes, this is a genuine replacement part, but compatibility depends entirely on your specific axle and steering setup.
Compatibility Note: The TeraFlex Heavy-duty Tie Rod End (Part #4920201) features a Large Taper (designed for standard Dana 60 or Tera60 knuckles) and a 7/8" x 18 Left-Hand Thread. It is intended as a direct replacement component specifically for TeraFlex heavy-duty steering systems or custom setups built around 1-ton Dana 60 axles.
Stock Warning: It is not a direct replacement for a factory stock Dana 30 or Dana 44 front axle with standard factory knuckle tapers, as the taper hole will be too large.
Compatibility Note: The TeraFlex Heavy-duty Tie Rod End (Part #4920201) features a Large Taper (designed for standard Dana 60 or Tera60 knuckles) and a 7/8" x 18 Left-Hand Thread. It is intended as a direct replacement component specifically for TeraFlex heavy-duty steering systems or custom setups built around 1-ton Dana 60 axles.
Stock Warning: It is not a direct replacement for a factory stock Dana 30 or Dana 44 front axle with standard factory knuckle tapers, as the taper hole will be too large.
Walter L.
What is the diameter and thread count for this end?
This is 7/8"-18 left hand thread. Thank you for the question.
Gavin H.
Will these work with a stock tie rod tube?
No, they will not. They are replacement ends for use with Teraflex's HD steering Linkage Kits. Thanks for your inquiry.
FRANCISCO M.
I have this steering kit in my JKU (Steer Smarts YETI Series Extreme Duty Tie Rod Assembly). Is this tip used for replacement?
No, this is for Teraflex HD steering linkage as replacement components. Yeti may offer service parts on their web or by reaching a specialist. We could special order parts our vendors make available for purchase. Thanks for your inquiry.