Reviews for Mopar 82210214AB 7 Way Round Trailer Connector for 07-18 Jeep Wrangler JK
I thought the instructions could have been written better. Plugged right up and works well . I have a factory wired 4 way flat . Leave that alone and plug this up as the instructions show. The 4 way works and the 7 pin works giving me the option to use either one.
Everyone said is right, but the lenght of the wires for an unlimited are quite tight.. Just enough not more had to do some adjustments.. From the ground is kind of a pain to go back and forth to each position under the Jeep as I got no lift kit but it can be done. Instructions were ok but add more zip tie youll need more to secure your harness the ones they giving are ok but cheap. I add more than enough to make sure nothing happen cause it pass close from moving parts.. Have fun, No programmation needed thats bs from dealer to make more money! Mine was asking 3 hours to do it at 94$/hr + reprogramming of the computer of the Jeep I then saved more than $450!
I just installed this harness this weekend and the install was pretty easy and straightforward. The instructions could be better if they used actual works instead of cartoon diagrams. The harness is made for our Jeeps by Mopar and nothing has to be spliced in. The harness plugs into the driver's side tail light then the harness gets routed under the vehicle and connects to the battery terminals. The blue wire in the harness is for a brake controller. My popup camper does not have trailer brakes so I just rolled the wire up and zip-tied it under the hood.
Installed on 2017 Sport Unlimited without issue, directions were a bit confusing. plug continuity confirmed. Install approx. 1.5 hours without lift.
I had this installed at the Dealer, it works perfectly.
I only wished that they would put better instructions, you know like WORDS....
Other then no written words to install it on your own. it works perfectly.
The 7-way connector is not as good as described
My jeep is a 2-door wangler, made in 2010. When I installed it according to the instruction, all the lamps don’t work normal except rear clearance lamps and License Plate Lamp. When I brake, the left turn lamp of the trailer will flash. when I back up the wrangler, the brake lamp of the trailer will work. when I turn on the left turn lamp, the right turn lamp will flash. it is so horrible. And the right lamp will never work. I think, it is impossible to work, because the wire is only connected to the left rear lamp of wrangler and there is no right signal.