Reviews for Rugged Ridge 11630.20 All-Terrain 4.75" Fender Flare Kit for 97-06 Jeep Wrangler TJ
Closes size to my 2004 jeep Rubicon original size of 4.25
Great fit. The use of blue painter tape to temporarily hold the seal works very well
Right size.
Kind of pricey for what you get, but once installed they look great and are far sturdier than they seem initially when not yet on the Jeep. I got these to replace cracked stock fender flares.
These may not hold up under heavy abuse off road, but if you are replacing stock ones that are damaged or looking for a nice upgrade to the look of your Jeep these are great!
Installation was challenge but certainly not the hardest job a Jeep calls for sometimes. For the rear flares, remove the Well Liners. Trying to install these with them still on makes it far more difficult. The plastic tabs holding it in come out easy enough. The front flares are very easy and straight forward albeit a bit time consuming.
Definitely a recommended upgrade!
Looks great! Put all the bolts through BEFORE fully tightening. The rubber rim trim piece is a pain to install, you do receive extra length. Overall, the final result looks amazing, we should have changed these out YEARS ago.
Easy install and looks good
I rarely say that I am "completely" satisfied with a product, but I can honestly say these flares were "exactly" as described and fit perfectly! No regrets, and lots of compliments on them!
Replaced an old set of more expensive Bushwackers. Better quality and fits perfect! Take your time with the edge molding using the "blue tape method" (see prior reviews). Great product!
these look good, kind of a pain to install because the old bolts are rusty.
Application: I purchased JK take off wheels and tires for my TJ, and used wheel adapters (4.5" to 5") for mounting. These fender flares are the perfect width to cover my tires, showing a little bit of the tire for that mildly aggressive look.
Installation: I just purchased this kit and mounted the fenders last weekend. They installed relatively easy - had to pull out the wheel well liners in the back, and remove the battery to mount the front passenger side.
Why only 4 stars: It gets 4 stars because the list of parts does NOT include mounting hardware, but the kit actually does include SST bolts/washers/nuts. I purchased the flare mounting kit (11603.09) but am returning it. I'm disappointed that Quadratec didn't question the purchase of the fender kit and fender mounting kit together. It seems like that might send me an email or called to ask if I really needed the mounting kit knowing it comes with hardware.