Reviews for Rugged Ridge 11503.96 CB Antenna Mount Kit for 07-18 Jeep Wrangler JK

This is a great end-to-end solution for mounting all of the hard parts for both the radio and antenna!

Works great with my President Johnny 3. If you want the overhead mount I highly suggest you seek out the smallest, lightest weight radio to your liking to avoid rattling and bouncing up and down.

Fit good easy to do.

Got this to mount a truck cell phone antenna, as mounting possibilities are limited on a 2018 JK.
The product was well made and fit exactly as needed, including the radio mount (you need to wrestle off your plastic panel by the windshield).
My only complaint is the cheap bolts that come with mount. this is easily rectified by a visit to a nearby hardware store and spending a couple of bucks.
I would recommend this product to others, as it is very stout compared to the others, and has the correct bend in it to make the antenna base level, unlike the cheaper ones I have seen, and you will break the antenna mast before the mount (even a spring one). This is a very thick mount compared to most.
Product was very well packaged from Quadratech as well!
Excellent Service too!

Frederich S.

Works as advertised.

the product was all that I assumeed it would be. good quality. although, since I have a 2008 I had to drill out the rivets that held the footman loop in and replace it with the rubber well nuts that were supplied with the kit. I do not like the rubber well nuts so I instead purchased some metal jack nuts and I found it holds much better.

Decent price. Hopefully it will work as expected.

Fits and works good. The radio does vibrate a little bit and isn't centered. If you have OCD it might drive you nuts. After I bought the antenna mount I bought a terra flex tire carrier, I was able to make it fit with some modification

The radio mount is great! Gets the radio up out of the way, above the Mirror, the loop is perfect for keeping the cable out of the mirror and your face when not using the CB.
The antenna mount is a different story. needed to grind off the powder coat in order to ground and the steel is too thick for the Firestik antenna mount. had to grind down about 1/32