« Back to product
Chadwick R.
Is there a difference in the motors for a RHD wrangler?
The core engine block, cylinder head, and internal components would have been identical between LHD and RHD versions. The key differences in the engine bay of an RHD Jeep YJ would primarily relate to the placement and routing of components due to the reversed steering system. These differences might include:
Steering Linkage and Steering Box: These would be located on the right side of the vehicle.
Brake and Clutch Master Cylinders: While the components themselves might be the same or very similar, their physical location and the linkage to the pedals would be mirrored on the right side.
Wiring Harness Routing: The main wiring harness would need to be routed differently across the firewall to accommodate the reversed dashboard and controls.
Vacuum Lines: The routing of vacuum lines might be slightly different to connect to components on the opposite side.
Possibly different length or shaped hoses and cables: Items like heater hoses, coolant hoses, and throttle cables might have different lengths or shapes to reach their respective components.
Air Intake and Exhaust Manifold Placement: While the core design would be the same, their exact orientation or the path of the intake ducting and exhaust piping could have minor variations due to packaging constraints in the reversed engine bay, although this is less likely for major components like the manifolds themselves.
Steering Linkage and Steering Box: These would be located on the right side of the vehicle.
Brake and Clutch Master Cylinders: While the components themselves might be the same or very similar, their physical location and the linkage to the pedals would be mirrored on the right side.
Wiring Harness Routing: The main wiring harness would need to be routed differently across the firewall to accommodate the reversed dashboard and controls.
Vacuum Lines: The routing of vacuum lines might be slightly different to connect to components on the opposite side.
Possibly different length or shaped hoses and cables: Items like heater hoses, coolant hoses, and throttle cables might have different lengths or shapes to reach their respective components.
Air Intake and Exhaust Manifold Placement: While the core design would be the same, their exact orientation or the path of the intake ducting and exhaust piping could have minor variations due to packaging constraints in the reversed engine bay, although this is less likely for major components like the manifolds themselves.
Lance M.
What is the "park" position of the wiper? Do they stop in the middle of the windshield or lay down?
YJ park position is in the windshield glass view at about a 45 degree angle. They do not lay flat. Thanks for your inquiry.
HENRY M.
does this motor have 2 speeds
Yes this is a two speed wiper motor, with the speeds being regulated by the brush arrangement inside the case.
Chad H.
Is this a intermittent motor or is just hi and low?
There is only 1 motor listed for the YJ wranglers. The intermittent operation is controlled through the switches on the column and dash. This will function as your motor was optioned from the factory.