« Back to product
Steven G.
I installed the Quadratec 2.5” lift kit on my 2003 Wrangler CJ and getting vibration when I accelerate. What drive shaft do you recommend to address this condition? Any other parts needed beyond drive shaft?
A slip yoke eliminator should be used with Cv drive shaft for use with SYE. if it is not a Rubicon model is needed if a transfer case lowering kit is not able to relieve the vibration.
Sandy J.
Jeep tj rubicon 6” 4 link suspension lift
Tom Woods rear driveline - what are the length specs for this driveline? Specs in your online catalog show 48” length which is obviously wrong for rear driveline. Thanks
What you see listed is a shipping dimension. This drive shaft is 16.75” face of flange to center of u-joint in the running position.
Anthony P.
Have an 05' Rubicon, want to put 3'' teraflex lift on it do i need a trans drop kit? Jeep has a 2.5" RC lift on it now with no drop kit or longer driveshaft. Thanks
You would only need this new drive shaft. The Rubicon transfer case is built to handle that.
Mark W.
will this work with the 2006 LJ Unlimited?
No it will not. For the Unlimited please see 52301.915
Charlie C.
Does this have the double cardan? I'm putting a 3" lift with 33" tires on my TJ. Also need a SYE, can you recommend one?
Yes this is a double-cardan shaft, but this shaft is for a Rubicon. If you have Rubicon then you do not need an SYE with your transfer case, only the driveshaft.
James V.
Will this Driveshaft work with an 06' TJ Rubicon?
Yes as long as you have 2-6" of lift
Andy D.
What U joints are used in this driveshaft.
This driveshaft uses 1330 u-joints
Brian K.
What is the length of this drive shaft?
This drive shaft is 16.75” face of flange to center of u-joint in the running position.
ANDRIES C.
I have this drive shaft and nor sure which u-joints it uses.
Need to know if this shaft is a 1310 or a 1350
Regards
Stefan
Hello, this drive shaft uses 1330 u-joints. Thank you for your question.