« Back to product
Timothy B.
Hi, will this fit with body armor bumper? JK-19532
The Quadratec Aluminum Modular Front Sway Bar Skid Plate (#12057.1211) is generally compatible with the Body Armor 4x4 JK-19532 Front Bumper, but there is one specific detail regarding your installation that you need to check.
The only potential conflict with Body Armor bumpers occurs if you have already installed a steering stabilizer relocation bracket that uses the same factory holes on the crash bar.
If your JK is still using the factory steering stabilizer location, the skid plate will bolt right up using the existing holes in the lower cross-member.
The only potential conflict with Body Armor bumpers occurs if you have already installed a steering stabilizer relocation bracket that uses the same factory holes on the crash bar.
If your JK is still using the factory steering stabilizer location, the skid plate will bolt right up using the existing holes in the lower cross-member.
Robert C.
Will this fit with the Quadratec Modular front bumper?
No, it will not. Sorry for the inconvenience.
G P.
Some ‘answers’ state works with certain aftermarket bumpers. Some ‘answers’ state it ONLY works with stock bumper. I want to get this for the Rugged Ridge Arcus bumper; is this compatible please? Thank you kindly.
We don't have direct fit data, but based on the Arcus allow a clear access to the JK blocker beam where the sway bar skid brackets will mount, I would expect if there was a conflict present, it would likely be very minor space tolerance and if some of the edge of the aluminum on the skid was trimmed from it, fit could be attained. Sorry we do not have specific data we can use to confirm the fit. Thanks for your inquiry.
Jamie K.
Does this work with the carnivore full length bumper?
This will fit with a very tight tolerance and it sits right next to your fog lights when mounted, but it will fit. Thanks for your inquiry.
Keith C.
Does this work with stock bumper and a bull bar
This skid has not been tested with any aftermarket brush guards or bull bars that mount below the factory bumper. We would expect conflict with guards that have mounting points below the factory front bumper bottom surface. Guards that mount to the top of the factory bumper should be just fine. Thanks for your inquiry.
Justin N.
Will this work with all other brand bumpers?
Not necessarily, but if the back edge of the lowest surface of the bumper doesn't come back far enough to block mounting points, it should be able to fit along with many brands bumpers. Review the install instructions of both products closely and if there are any mutually shared mounting points, it will not fit. Thanks for your inquiry.
WILLIAM S.
Is this swaybar skid plate compatible with the quadratec qrc front winch ready bumper?
Yes, it does. Perfectly. They are a great complement to one another. Thanks for your inquiry.
Brian C.
Will this skid plate fit a 09 JK Unlimited Rubicon
This will fit all factory bumpers.
Harley P.
Are these plates paintable?
Yes.
Larry R.
Are these made in USA?
No they are not