Reviews for Mountain Off-Road ARB18 Dual Compressor Mounting Bracket for 18-22 Jeep Wrangler JL Unlimited
Great bracket. The only challenge was the tight fit near the rollbar housing. The tight fit made it a little difficult for installation. Only had installed a couple weeks but no complaints with noise or concerns with support. Location does make it a challenge mounting a manifold close enough for the braided hose.
The fit was perfect I have it mounted which took no time. Pre-wired and ready for the compressor.
I see now way it will fit 2024+. In my case there is no space there becasuse of the new panel design.
Not well thought out. Just because you can mount a compressor in the rear of the Jeep doesn’t mean you should. The mount rattles over every wrinkle in the road. So much so i stuffed foam behind it just to get it to stop. Then i noticed the crack as a result of its hanging and constant rattling.
I had to purchase 100 bucks worth of wire and heat shield to install it all. Also, i had to locate a video on how to modify the wiring harness to have the compressor mounted in the rear.
After it was all said and done, I kind of like it.
Would i do it again? No. I’d buy an air tank.












