Crown Automotive JA001488 Front Brake Line for 41-59 Willys and Jeep CJ Series

These pre-bent lines made it a breeze to swap out the wheel cylinders and cost less than buying the material to make.

Was not even CLOSE to fitting properly. Each bend was too big, the top and bottom "legs" of the S were too long and had to be cut shorter, and the overall height was too tall. After heavily modifying one of these trying to get it to fit, I eventually ended up kinking one of the bends and had to throw it in the trash. For $3 you might think you're saving yourself some time, however you will be severely disappointed once you see how far off these are. Buy brakeline yourself, flare each end, and fill the line with fine sand so that you make the tight bends. Just make sure you clean out the sand good before you install. The black painted line is one of these lines unmodified, the bare steel line is how much I had to modify the line before it would fit a '51 M38.