DV8 Offroad FBSHTB-17 FS-17 Hammer Mid Width Front Bumper for 07-24 Jeep Wrangler JL, JK & Gladiator JT

Installation of this bumper is a nightmare. There’s no installation instructions for the bumper (what you see on Quadratec's webpage are for a different bumper), the bumper’s upper bracket for the LED light bar will need to be modified to fit onto the main bumper if you’re using the new Warn 12 Ton because the two will rub. the lower LED light bar (DV8) does not fit into this DV8 bumper without modifying the slot with a Dremel or the like. Just getting a wrench or a socket on some of the mounting bolts is difficult. All total, with bumper, lights, wiring harnesses and the $75 for the bumper standoffs that were required for my Gladiator install...this is every bit of $850-$900 bumper. This not the only aftermarket, bolt-on bumper I’ve purchased or installed. I’ve done several but this one was the most aggravating and time consuming. This is not the only DV8 equipment I purchased but they all share a common flaw so I’ll finish with this…none of the DV8 items I purchased came with a parts list or an assembly drawing. So buyer beware if you plan to install this front bumper setup!