Flowmaster 817752 Outlaw Axle Back for 07-18 Jeep Wrangler JK

The exhaust was easy to install. The old exhaust took a little elbow grease but following tips people have provided made it easier. Looks and sounds incredible. The one draw back is that over time, the high heat caused the black ceramic coating to wear off in the center of the exhaust. After contacting Flowmaster, that said that was normal, but I wasn't happy with the change in the look. They suggested using a can of high heat black spray paint to cover up the area. Not ideal, but I followed their direction and it looks brand new again.

Overall good fit and easy to install. Since I was replacing I just cut the old brackets off with sawzall. Make sure you cut off the muffler brackets only and then it’s easy to pull off old muffler. The brackets that go onto the duel pipes be careful not to over tighten like I did as they will break. (Just one). I do like the sound and does look good from the ass end

Just slapped the outlaw on last night....taking the old one off was a bit of a pain (1.5 hours)...finally got the hanger rods loose from the grommets using white grease & channel locks to squeeze the stub end of the rod through the grommet. Slapped the new one on in about 15-20 ... I also suggest putting hose clamps at the end of the new hanger rods as they don't have the stubs like the factory one & could slide out with enough force...all in all I loooovvve the sound & feel like there's a little more umph on the throttle..two thumbs up!!! Perfect addition to my Banks Ram Air intake :)