Teraflex 1353100 Heavy Duty Ball Joint Set without Knurling for 84-06 Jeep Cherokee XJ, Comanche MJ, Grand Cherokee ZJ, Wrangler YJ & Wrangler TJ

• Extremely hard sintered wear bushings to handle extreme side load demands without failure
• Magnesium Phosphate coating to inhibit corrosion throughout
• Heat treated 4140 chromoly ball/stud & 1045 carbon steel housing
• Factory style serrated flange nut & grease fitting
• Without knurls

• Hard alloy tool steel slotted wear plate for ball / stud to socket wear protection
• Wear plate features grease channels for increased flow through entire joint ensuring longevity & predictable operation
• Magnesium Phosphate coating to inhibit corrosion & friction throughout
• Heat treated 4140 chromoly ball / stud
• Huge 30mm (1.18”) ball
• Factory style serrated flanged castle nut
• Ball joint pre-load adjustability provides the end user w/ near effortless wear adjustment (kid includes Preload Adjustment Tool)
• Low-profile single lip dust seal eliminates torn conventional dust boot concerns
• Adjustable ball stud retaining ring for accurate initial & future preload adjustments that can be done w/out any axle disassembly
• Adjustable preload can be performed with simple hand tools
• Adjustable end cap with two (2) zerk fittings (“Frog Eye”) allow greasing access from either side w/out axle shaft removal even with larger RCV shafts
• Dual helical grease grooves machined in the retaining ring allow spent grease to exit through the low-profile seal
• Low-profile seal prevents contaminants, while allowing spent grease to evacuate from the ball joint
• Without knurls

• We recommend ball joints without knurls (1355100) as they will not score the inner knuckle & open up the bore.
• Also offered with knurls (1355300) for ball joints with a loose press fit in the inner knuckle due to repeated ball joint replacement or if knurled ball joints have been installed in the past.

Note: Will not fit RCV High Performance Axle Shafts

Installation Notes

Installation Difficulty:

Level 2Intermediate

We recommend ball joints w/out knurls (1355100) as they will not score the inner knuckle & open up the bore.

Also offered w/ knurls (1355300) for ball joints w/ a loose press fit in the inner knuckle due to repeated ball joint replacement or if knurled ball joints have been installed in the past.

Installation Time: 3-4 hours

Parts Included

• Upper Ball Joint - Pair
• Lower Ball Joint - Pair
• Grease Fitting Tool
• Nuts
• Cotter Pins

Warranty

Limited Lifetime