Home » Jeep Electrical » Wiring » Wire Wrap » Daystar Firewall Boot

Daystar KU20040BK Firewall Boot

Quadratec Part #: 12500.0000
Daystar Part #: KU20040BK
Description
When wiring up accessories that need the wires to go through the firewall, finding a good spot can be a challenge. With the Daystar Firewall Boot, that challenge has become an easy task. All that is needed is to drill a 1.25" diameter hole in the firewall, and then push the boot into place. After that, its as easy as running the wires through the boot and then trim the boot to the desired length. The boot will protect the wires from sharp edges and keep out water leaks and airflow. Works great for tubing and air lines too! Boots are sold individually.
Details
Safely and cleanly run wires through firewalls and bulkheads: Simple to install, drill a small hole and place the boot into the firewall. Run the wires through and you are done! The boot will protect the wires from chafing against sharp edges that could result in shorts.

Eliminates air & water leaks: With the Boot in place, it creates a seal that will not allow water or air penetration, keeping wires safe and dry.

Fits a variety of wire thicknesses and bundles from 3/8" to 1": Simply trim the boot to the desired size after installed.

Works great for tubing and air lines, too!

1.25" diameter hole required for installation.
Installation Notes
Installation Difficulty:
Level 3Advanced

1. Drilling Required.

Installation Time: Less than an hour
Parts Included
  • Daystar Firewall Boot
Warranty
1 Year Warranty
  • Shipping Weight: 1lb
  • Shipping Dimensions: 8in x 5in x 2in (L x W x H)
Share Your Thoughts
Review Summary
5
Based on 2 reviews
Shared Media
Questions

Customer Submitted Photos

Daystar Firewall Boot Reviews