- Features: Metal, Plastic, Rubber
- Shipping Weight: 1.6lb
- Shipping Dimensions: 9in x 4in x 4in (L x W x H)
Customer Submitted Photos
Hella ValueFit Two Light Wire Harness Reviews
I used this harness to power the higher wattage bulbs in my new Rampage lamp housings.. No complaints! The wire is heavy duty. I made going to a "relay headlamp system" easy!
Plenty of length to go from battery to the front bumper for bumper mounted LED fog lights (Rugged Ridge 11232.27 LED Round Fog Light) in a Rampage Rock Rage Front Bumper. Had lots of wiring left over in the engine compartment near the battery of my JK. There is a prong connector that disconnects the switch wire from the rest of the harness. The connector is boxy, so I had to run it along the top of the engine compartment to the drivers side to get a big enough hole to get it into the passenger compartment. I was then able to join and snap the connector together on the drivers side behind the console. Still had a few inches of wire to the switch to play with. The on/off switch is a little cheap. I removed the 3 wires from the switch, put bigger connectors on them and connected it to a full size rocker switch in a panel of other rocker switches. The entire harness has a nice plastic/rubbery coating so it looks like it will hold up to the elements where the harness might be exposed.
I chose to solder instead of using the connectors supplied. I used these for my pod lighs near the windshield corners, and my only complaint is that there is too much wiring to tuck away when finished. I ended up mounting the relay near the driver side firewall and had to extend the power line going to the battery. Because the wiring going to each accessory is the same length, I was left with a bunch of spaghetti wires after. However, I am very satisfied with the results.