Hooker Headers 70405401-RHKR BlackHeart Axle Back Exhaust System for 07-18 Jeep Wrangler JK
This part is legal for use on Emissions Controlled Vehicles when used in accordance with the manufacturers application guide because it has a California Air Resources Board Executive Order number or is a direct or consolidated replacement part.
- Features: Turndown Tip
- Color: Silver
- Material: Stainless Steel
- Type: High Clearance Axle Back
- Shipping Weight: 25lb
- Shipping Dimensions: 42in x 29in x 9in (L x W x H)
Jeep Wrangler 2-Door (JK)
- 2018 Jeep Wrangler 2-Door (JK)
- 2017 Jeep Wrangler 2-Door (JK)
- 2016 Jeep Wrangler 2-Door (JK)
- 2015 Jeep Wrangler 2-Door (JK)
- 2014 Jeep Wrangler 2-Door (JK)
- 2013 Jeep Wrangler 2-Door (JK)
- 2012 Jeep Wrangler 2-Door (JK)
- 2011 Jeep Wrangler 2-Door (JK)
- 2010 Jeep Wrangler 2-Door (JK)
- 2009 Jeep Wrangler 2-Door (JK)
- 2008 Jeep Wrangler 2-Door (JK)
- 2007 Jeep Wrangler 2-Door (JK)
Jeep Wrangler Unlimited 4-Door (JK)
- 2018 Jeep Wrangler Unlimited 4-Door (JK)
- 2017 Jeep Wrangler Unlimited 4-Door (JK)
- 2016 Jeep Wrangler Unlimited 4-Door (JK)
- 2015 Jeep Wrangler Unlimited 4-Door (JK)
- 2014 Jeep Wrangler Unlimited 4-Door (JK)
- 2013 Jeep Wrangler Unlimited 4-Door (JK)
- 2012 Jeep Wrangler Unlimited 4-Door (JK)
- 2011 Jeep Wrangler Unlimited 4-Door (JK)
- 2010 Jeep Wrangler Unlimited 4-Door (JK)
- 2009 Jeep Wrangler Unlimited 4-Door (JK)
- 2008 Jeep Wrangler Unlimited 4-Door (JK)
- 2007 Jeep Wrangler Unlimited 4-Door (JK)
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review
Hooker Headers BlackHeart Axle Back Exhaust System Reviews
Size
I like them good fit and sound
Love the sound and look of this exhaust, and the clearance is much better than stock! We did run into one fitment issue with it on a 2016 JK Rubicon Hard Rock with 3 inch lift, presumably due to an exhaust spacer having been installed. When first installed, we had VERY little clearance with the rear bumper and also had to move the trailer wiring out of the way due to heat fears. After speaking with Holley Performance, they stated that the original exhaust must sometimes be cut for proper fitment. We ended up cutting off 3/4" off the original (all that can be cut due to the stock bend in that pipe), and the clearance was much better. Other than that, installation was relatively easy. Another tip... putting dish soap on the exhaust hangers really helps to get them on and off.