Skip to main content
Home » Jeep Bumpers » Rear Bumpers & Tire Carriers » Rear Bumper Accessories » Mopar Steel Rear Bumper Fascia
« Back to product
Can i replace the plastic outter shell is the steel one? Are the brackets the same?
Only 1 bracket is common between the bumpers. You would have to purchase a considerable amount of parts to swap out the bumper fascias
Thank you for a prompt reply, OK, we forget the drilling - if I buy the full set of rear steel bumper #82215342 and this shell - will this work, or it will not fit? Are the shells different With and Without sensors' holes?
In this case the bumper shells are the only difference. The underlying support structure, brackets and closeout panels are all the same. The shells are interchangeable.
Hello! If I have the EURO-spec Rubicon with plastic rear bumper WITH parking sensors - is it possible to order rear steel bumper set that comes WITHOUT holes for parking sensors (#82215342) and just buy additionally this shell with openings. Or it's easier/cheaper just to drill them? :) Thanks!
Drilling is always cheaper but not really easier. In order for the sensors to work properly they have to be in very specific relation to each other. If you try to drill you run the risk of the sensors not working properly.
What other parts are needed? I assume 2 bumper brackets, but also some additional bolts and parts ?
This is a replacement bumper shell only for Jeep Wrangler JL with factory installed Parking Assist. If your vehicle does not have the sensors in the bumper from the factory then you would have to send your Jeep back to have the system installed from the ground up.
does it fit wrangler JL sport 2019 perfectly without cutting ?
Yes this replaces the original Park Assist Bumpers without cutting.