Reviews for Quadratec QRC Front Winch Ready Bumper for 18-24 Jeep Wrangler JL & Gladiator JT

This bumper fit perfectly onto my 2025 Wrangler Rubicon. The stock fog lights were easy to install. It looks really great and I have made use of both the top and upside down light mounts. I love the way the winch mount is recessed down into the bumper. Really looks clean and leaves the radiator open to the wind. Only negative I can find is that it is really heavy. Not far beyond what other bumpers of this size weigh but something to keep in mind as you are adding weight to the front end.

This bumper is awesome. I'm a fabricator and this bumper is built to take a beating. It has everything a Jeep owner would want.

Great looking and well made..

Bumper looks amazing and has amazing welds all around. Getting the Willys Sport S fog lights to fit with the bumper took some finagling, but fits perfect in the end.

Love the look of this bumper.

It was fairly easy to install. It looks great. Make sure you mount the winch first before you stab the bumper. I mounted the Badlands Apex 12000 it's tight but fits fine.

Love this bumper, looks great on my 2021 JL. Easy install, added the ResQ Teton which, fits like a charm. Pulled Diode Dynamics fog lights from old bumper and installed here easily. Great bumper and always great Quadratec service.

This bumper is tough. Zero damage after a collision. I am a lifelong fan of Quadratec now. I reccomend to all my friends. Install was simple, my son and I knocked it out in about 3 hours.

*Apex Badlands 12k winch is a tight fit, be mindful of your wires.

Great bumper. Only problem is winch lies too close to grill.

Execellent Bumper! went on easy peasy. Really appreciated the welded on Studs so that you dont have to finagle a piece of tape or clear plastic to hold it in place. Just lift it up and stab it on, the nuts are welded on also , I put it on by my self.. now I suggest putting the winch on first , you'll prob need help with the added weight.
This went on my 23 Gladiator Mojave.
**Attention Mojave owners.** NO MODS NEEDED . despite what you read, NO MODS NEEDED to put back on your factory Skid Plate.. Just put the front 2 on like usuall.
THEN.. It brings things in alignment in the back but leaves about a 1" gap. Hey No Prob.. just grab your floor jack, crank it up with a little pressure Viloa.. all 4 bolts are on without cutting or Moding your factory nice thick front skid that protects your Fox Reservoir's...