« Back to product
STEPHEN F.
I have an 1988 wrangler with a NP 231 transfer case with a slip yoke eliminator conversion. The Dana 35 rear axle has been upgraded a Dana 44
Will this part bolt into the Dana 44 axle yoke?
No, it will not directly bolt up without verifying your axle yoke's U-joint series.
Why It Might Not Fit:
U-Incompatible Joint Series: The Rough Country 5078.1 drive shaft comes equipped with 1310 series universal joints to match the factory 1987-1993 YJ specifications.
Dana 44 Yoke Variations: Depending on what vehicle your Dana 44 axle was pulled from (or if an aftermarket pinion yoke was installed), it may feature a larger 1330 series or 1350 series U-joint strap pattern rather than the standard 1310.
If your Dana 44 has a 1310 yoke, it will bolt right up. If it uses a larger series, you will either need a conversion U-joint (such as a 1310-to-1330 joint) or a matching pinion yoke swap.
Why It Might Not Fit:
U-Incompatible Joint Series: The Rough Country 5078.1 drive shaft comes equipped with 1310 series universal joints to match the factory 1987-1993 YJ specifications.
Dana 44 Yoke Variations: Depending on what vehicle your Dana 44 axle was pulled from (or if an aftermarket pinion yoke was installed), it may feature a larger 1330 series or 1350 series U-joint strap pattern rather than the standard 1310.
If your Dana 44 has a 1310 yoke, it will bolt right up. If it uses a larger series, you will either need a conversion U-joint (such as a 1310-to-1330 joint) or a matching pinion yoke swap.
Chris M.
I got the 4.5 inch lift. Will this drive shaft for that lift? It says for use with 6”, but also says 4”
This Rough Country Rear CV Drive Shaft is designed to work with 87-93 YJ Wranglers with 6” of lift.
Gregory A.
Will this fit with a 6'' lift?
Yes. This CV Drive Shaft is meant for use with 6” of Lift. Also, a Slip Yoke Eliminator is Required.
Mikey D.
I did not see it listed. Are the collapsed and extended dimemsions center of u-joint cap to center of u-joint cap?
Collapsed Length: 17.375in Extended Length: 20.875in
Justin D.
What are the lenghts compressed and fully extended?
Collapsed Length: 17.375in
Extended Length: 20.875in
CIRILO V.
Hi! Is this CV drive shaft comparative with a Rubicon Express slip yoke eleminator?
Yes, it is compatible with any standard slip yoke eliminator