Rough Country 5078.1 Rear CV Drive Shaft for 87-93 Jeep Wrangler YJ
Eliminate vibration and strengthen your Jeep’s drivetrain with the Rough Country Rear CV Drive Shaft. This 100% bolt on driveshaft was specifically engineered for use with early model YJ Wranglers. With a heavy-duty design and Brute Force Red Seal u-joints, this drive shaft is twice as strong as the factory version. Best of all, Rough Country designs and manufactures all of their driveshafts right here in the USA!
Installation Note: This CV Drive Shaft is meant for use with 6” of Lift. Also, a Slip Yoke Eliminator is Required.
Heavy-Duty Design: This drive shaft is twice as strong as the factory drive shaft. It features greaseable Brute Force Red Seal u-joints, and a double cardan design.
Bolt-On Installation: For ease of install, the Rough Country Rear CV Drive Shaft mounts to your Jeep without cutting, drilling, or other modification. This kit a CV drives shaft and installation hardware.
Vehicle Fitment: This Rough Country Rear CV Drive Shaft is designed to work with 87-93 YJ Wranglers with 6” of lift.
Collapsed Length: 17.375in
Extended Length: 20.875in
- Engine: 2.5L, 4.0L, 4.2L
- Transmission: Automatic, Manual
- Location: Rear
- Shipping Weight: 22lb
- Shipping Dimensions: 29in x 5in x 5in (L x W x H)
Jeep Wrangler (YJ)
- 1993 Jeep Wrangler (YJ)
- 1992 Jeep Wrangler (YJ)
- 1991 Jeep Wrangler (YJ)
- 1990 Jeep Wrangler (YJ)
- 1989 Jeep Wrangler (YJ)
- 1988 Jeep Wrangler (YJ)
- 1987 Jeep Wrangler (YJ)
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review
Questions
Why It Might Not Fit:
U-Incompatible Joint Series: The Rough Country 5078.1 drive shaft comes equipped with 1310 series universal joints to match the factory 1987-1993 YJ specifications.
Dana 44 Yoke Variations: Depending on what vehicle your Dana 44 axle was pulled from (or if an aftermarket pinion yoke was installed), it may feature a larger 1330 series or 1350 series U-joint strap pattern rather than the standard 1310.
If your Dana 44 has a 1310 yoke, it will bolt right up. If it uses a larger series, you will either need a conversion U-joint (such as a 1310-to-1330 joint) or a matching pinion yoke swap.
