Reviews for Synergy Manufacturing Air Compressor Bracket for 07-18 Jeep Wrangler JK
Changed my mind
Solid platform for mounting a compressor. No issues with install or finish on the bracket. Highly recommend !!!
This is a great product that solves the problem of where to mount a compressor under am already cramped engine bay. The bracket is made of a decent gauge steel. However, the description states that it will fit the ViAir 450 Series, this is a half-truth. Yes, it will fit, but the mounting holes will not line up to the bracket, no matter which way you try. This left me only able to use two screws on the front of the compressor and then had to use a large heavy-duty cable tie to hold the back side of the compressor to the bracket. The only other thing is that the bracket mounts to the brake booster, so whenever the compressor turns on, you'll get a weird vibration through the brake pedal. Other than that, I would reccomend this bracket.
This was listed as the correct bracket but as far as I can tell this was the wrong bracket for the install of a High Output OnBoard ARB Compressor on a 2016 JK two door. Regardless the EVO bracket works much better.
DO NOT BUY the 2012+ version of this mount. The kit wants you to re-route one of the vacuum lines, and relocate a sensor. Problem is, the wire loom for the sensor is WAY too short to do what's instructed. I even tried shortening the vacuum hose supplied with the kit and work the sensor wires to try to pull some slack through. NOT EVEN CLOSE. Instructions don't even mention this, not helpful at all. In fact, the picture included appears to show the sensor wires pulled so tight they'd rip out eventually. 07-12 version doesn't look to require any of this, so it's probably fine. The mount itself appears to be of decent quality.