ARB Front Bull Bumper for 14-16 Jeep Grand Cherokee WK2
Quadratec Part #:
96010-2060
Description
Designed to fit the 2014 to 2016 Jeep Grand Cherokee 4x4 models, the ARB Deluxe Bar has been engineered and developed from the ground up. With various engine and model variations within the vehicle model line-up, ARB's engineers scanned different configurations of models within the WK2 Grand Cherokee range to ensure the bumpers fitment to all models post 2014 and newer.
Will not work with SRT8, Trailhawk or Overland models with park assist.
Details
- Durable steel construction for maximum protection
- Vehicle specific design to complement the WK2 Grand Cherokee 2014 on models
- Incorporates ARB's renowned multi fold upswept and tapered wing design for optimum strength and approach angle
- WK2 specific split pan to accommodate factory radar and provide access to winch handles
- Cover straps attached to the uprights ensure there are no exposed edges
- Continuous uprights through the bumper section of the bar strengthens the outer frame
- Superbly engineered, airbag compatible mounting system
- Tow point on right hand side mount
- Equally suited to both winch and non winch applications
- The bar adds approximately 5 3/4 inches to the overall length of the vehicle (including buffers)
- Approach angle is improved from 26° to 34° (standard coil suspension)
- Under panels protect vulnerable factory washer bottle and air compressor (Quadra-Lift® adjustable air suspension vehicles)
- Will accommodate Warn low mount electric winches up to 10,000lb
- Twin Hi-Lift jack points located in the pan of the bar
- Provision to accommodate a range of IPF & ARB Driving Lights
- Injection molded fog light / turn signal surrounds
- Durable urethane buffers
- Two antenna brackets located on the center frame of the bar
- Provision for factory parking sensors. Blanking plugs provided if no factory parking sensors
- Shipping Weight: 219
- Shipping Dimensions: 79in x 34in x 40in (L x W x H)
Jeep Grand Cherokee (WK2)
- 2016 Jeep Grand Cherokee (WK2)
- 2015 Jeep Grand Cherokee (WK2)
- 2014 Jeep Grand Cherokee (WK2)
Share Your Thoughts
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review
ARB Front Bull Bumper Reviews
Kendra H.
1/18/2023
Fit good once installed. Some of the installation was a little cheap but it will work just fine to save the front end from deer. Still have to cut & install the original bumper cover behind the ARB. Will also be installing a 2" leveling kit since it did drop the front about 1" from the weight of the bumper. The paint on the bumper is not very good. Will get it powder coated in the summer.
Questions
Josh K.
How much does this weigh? If the info is hard to get the shipment weight will do just fine.
thanks
The shipping weight is 75lbs
Jonathan R.
What are the clearances (aka max width/diameter) for the driving lights?
The measurement from the bumper to the bottom of the bull bar is approximately 225mm or 8.85".
Drew G.
How long would the installation of this bumper take? Considering it would be the first time with the Jeep on a lift and an excellent tool selection.
Sure thing, installation is really dependent on the installer. Something that takes one person and hour to install, could take someone else a whole day to install. We suggest taking a look at the installation instructions and then you can gauge the amount of work required properly for your level of skill: http://store.arbusa.com/Assets/PDF/3450420i.pdf
