Currie Enterprises Currie 60 Rear Crate Axle for 07-18 Jeep Wrangler JK

Description

Turn your Wrangler JK into a capable off-road machine with a Currie 60 Crate Axle from Currie Enterprises. The Currie 60 offers industry-leading ground clearance and extreme strength, all in one bolt-on package. This 35-spline Chromoly axle can easily run up to 37” tires and is tough enough to handle the horsepower of aftermarket engine conversions. The reverse cut Dana 60™ gears are available in three different common ratios. With the available selectable lockers, you will not need to worry about getting stuck out on the trail again. The high volume flow-thru recirculating oil system ensures superior cooling and bearing longevity. Every aspect of this Crate Axle was meticulously engineered for ultimate performance, strength, reliability, and length of service.

Details

Designed to Handle Severe Off-Road Abuse This Axle is Tough Enough up to Run 37” Tires on V8 Swapped or Hemi Conversion Jeeps.

High Clearance Built-In Skid Plate Constructed from AR400 Hardened Steel for Ultimate Strength and Rigidity. Protects the Differential Housing’s Radius Bottom and Can Slide Over Rocks and Obstacles Better Than the Competition’s Iron or Mild Steel Skids.

Heavy Duty High Pinion Currie 60 Axle Housing Manufactured from Stage-1 Nodular Iron with Thicker Reinforced Walls and Webbing. The Axle Tubes Are Over Twice as Strong as Factory 3” Diameter and .375” DOM. Features Red Nodular Iron Differential Cover with Integrated Upper Control Arm Mount.

Upgraded Input Yoke Accepts 1350 U-Joints. This Eliminates One of the Common Factory Driveline Points of Failure.

Currie Performance Axle Shafts Tough 1.7” Thick 40 Spline 4340 Chromoly Semi-Float Axle Shafts Utilize Set 80Tapered Roller Bearings. Pre-Installed Tone Rings Retain Factory ABS and ESP.

Dual Bolt Pattern Hubs This Axle Comes with 1/2" Studs Installed in a 5x5 Bolt Pattern. This Allows You to Retain Your Factory Brake Rotors and Calipers. The Hubs are Also Drilled for 5x5.5 So You Can Match Your Front Currie 60.

Improved Stance This Axle is 3.375” Wider Than Factory (68.75” Between Wheel Mounting Surfaces).

Perfect for Lifted Wranglers The Currie 60 is Optimized for 4” Lift Kits with 5 Degrees of Pinion Angle. Suspension Brackets Are Made from Heavy Gauge 3/16” Steel Plate and Have Multiple Mounting Holes That Allow You to Fine Tune Your Suspension Geometry.

Shipping Dimensions: 355 lbs. 82"L x 26"W x 21"H

Installation Notes

Installation Difficulty: