Magnum by Raptor Series Rear Bumper for 18-24 Jeep Wrangler JL

Very satisfied with this purchase. This bumper Is far more tough then the factory one It replaced. Pretty straight forward, and simple instal. I’d deff recomend

I don't know why people are overlooking this bumper. It is plenty solid with 1/8" steel shell and 1/4" supports/mounts. The shackle rings are through-welded, which is very important if you are someone that actually uses them.

I love the fact that the mounting system allows adjustment in any direction, which allowed me to get the gap I wanted against the body and higher up against the tailgate bottom. Maybe this amount of adjustment frustrates some buyers, but I appreciated it.

The design is quite nice and the wraparound corners fit the body line of the tub perfectly.

I had no use for the backup sensor holes, so I plugged off the two central ones with the included hole plugs. I put 3/4" LED backup lights in the other two.

The included third brake light LED really makes no sense mounted down so low, but I easily found the manufacturer of the included light and bought a white LED from Amazon and mounted it in the bumper. The fit is perfect by the way.

The included license plate bracket/LED assembly was nice, but I removed the LED from it and mounted it next to my license plate and directly to the bumper for a lower profile look.

In all, I am very happy with this bumper. It is very well built and matches the lines of my front Warn bumper quite well.

I set up this bumper. I like the look of it, but for me, three "negatives":
- Too bad the metal's too thin.
- the attachment for the sensors works, but another "cleaner" system would have been smarter to investigate
- I had to make two protective plates for the sensors located closest to the ground, because the connector and the wires are too exposed to splashes (mud, water, etc).