JcrOffroad's Crusader Mid Width Fender Flares for Jeep Wrangler JL & Gladiator JT models are designed for those wanting to increase tire clearance and ditch the factory plastic flares. The flares are CNC cut and formed from a combination of 3/16" and 1/8" Steel. JcrOffroad's Flares are fully fabricated and hand-built for unmatched fit and design. These aluminum fender flares include additional bracing so the flare is supported by the internal structure of the body support and not just the fenders. Daytime running lights, marker lights, and turn signal LED are included. These flares are available in your choice of front or rear pair in bare aluminum or black powder coat. Crusader Fender Flare widths are 7" for the front and 5" for the rear.
Note: Images are only shown in Black Powder Coat.
Note: On Jeeps equipped with incandescent marker lights (IE. not the LED lighting group) a resistor will need to be added to the turn signal wiring to cure hyper flash and to remove dash warning lights, we recommend part number DD4025 from Diode Dynamics (see below). Follow their instructions for wiring. (Luck has also been reported by those using the "LED Front Turn Signals" setting on the JL Superchips Tuner, no resistors needed.)
Note: On Jeeps equipped with the LED lighting group, removing the DRL, marker, turn signal module from the front fender will cause a "bulb-out" warning on the dash. There is currently no workaround for this.
Made in the USA!
