Por-15 45004 Rust Preventive Coating - Quart

Surface Preparation: To coat rusted or bare metal surfaces. Remove grease, oil, and other foreign substances using POR-15 water-based cleaner and prep products per the listed instructions. Stir POR-15 Rust Preventive Coating thoroughly, DO NOT SHAKE, then dispense a quantity of POR-15® Rust Preventive Coating into a separate container to avoid contamination. Application: Apply in thin coats. Always apply a minimum of two coats. If necessary, only thin with POR-15 Solvent, up to 5%. POR-15 Rust Preventive Coating may be recoated or topcoated when dry to the touch with a slight “finger drag”, typically 2 to 6 hours. To coat over cured POR-15 Rust Preventive Coating, scuff the surface with 320 grit sandpaper until gloss is dull, and then apply coating. Clean Up: Use POR-15 Solvent for clean-up, which must be done before POR-15 Rust Preventive Coating dries; once dry, POR-15 Rust Preventive Coating cannot be removed by any solvent. Use of gloves and ventilating equipment is strongly recommended. Avoid skin contact. Remove from skin at once to avoid temporary staining. Moisture will shorten the life of unused POR-15 Rust Preventive Coating. Seal can immediately after dispensing. Tip: Place plastic wrap between the lid and the can lip to prevent POR-15 Rust Preventive Coating from permanently sealing the can shut.