One bracket fits all 1997-2006 Wrangler TJs, including Rubicon and Unlimited.
No drilling, or modifications, are needed to either the seat, or floor, to accommodate these new brackets. Installation takes approximately 10-15 minutes per seat.
- Location: Driver Side
Jeep Wrangler (TJ)
- 2006 Jeep Wrangler (TJ)
- 2005 Jeep Wrangler (TJ)
- 2004 Jeep Wrangler (TJ)
- 2003 Jeep Wrangler (TJ)
- 2002 Jeep Wrangler (TJ)
- 2001 Jeep Wrangler (TJ)
- 2000 Jeep Wrangler (TJ)
- 1999 Jeep Wrangler (TJ)
- 1998 Jeep Wrangler (TJ)
- 1997 Jeep Wrangler (TJ)
Jeep Wrangler Unlimited (TJ)
- 2006 Jeep Wrangler Unlimited (TJ)
- 2005 Jeep Wrangler Unlimited (TJ)
- 2004 Jeep Wrangler Unlimited (TJ)
Well worth it. I'm 6'6 and this makes driving the 5-Speed manual way more comfortable. Relatively straightforward install, floor screws were a bit rusty and I had to buy a Torx T50 bit for the socket wrench to remove the anchor screw but other than that they went in easy.
Good product, easy install. Was back ordered and when received it there was no hardware just the brackets. Wasn't too hard to find hardware in our little town so wasn't a big problem.
First mod I did. A must-do for those over 6'. I am 6' 5" and I do not even need to push the seat all the way back. Extra 4" inches of legroom for the TJ, but only 2" (if I am correct) for the JK. One thing to note (not really a gripe, but rather an observation): I have had them in two TJs; I noticed that the powder-coating peels off relatively easily at the front edges, even after only a couple of months of use, and the metal underneath (steel) is prone to rust. It's just a cosmetic issue, nothing to do with functionality.