Crown Automotive 33003857 Plastic Valve Cover for 83-92 Jeep CJ & Wrangler YJ and 86-92 Cherokee XJ & Comanche MJ with 2.5L Engine
- Engine Size: 2.5L I-4
- Engine Fuel: Gasoline
- Shipping Weight: 5lb
- Shipping Dimensions: 22in x 18in x 6in (L x W x H)
Jeep Cherokee (XJ)
- 1992 Jeep Cherokee (XJ)
- 1991 Jeep Cherokee (XJ)
- 1990 Jeep Cherokee (XJ)
- 1989 Jeep Cherokee (XJ)
- 1988 Jeep Cherokee (XJ)
- 1987 Jeep Cherokee (XJ)
- 1986 Jeep Cherokee (XJ)
- 1985 Jeep Cherokee (XJ)
- 1984 Jeep Cherokee (XJ)
Jeep CJ-7
- 1986 Jeep CJ-7
- 1985 Jeep CJ-7
- 1984 Jeep CJ-7
- 1983 Jeep CJ-7
Jeep Comanche (MJ)
- 1992 Jeep Comanche (MJ)
- 1991 Jeep Comanche (MJ)
- 1990 Jeep Comanche (MJ)
- 1989 Jeep Comanche (MJ)
- 1988 Jeep Comanche (MJ)
- 1987 Jeep Comanche (MJ)
- 1986 Jeep Comanche (MJ)
Jeep Wrangler (YJ)
- 1992 Jeep Wrangler (YJ)
- 1991 Jeep Wrangler (YJ)
- 1990 Jeep Wrangler (YJ)
- 1989 Jeep Wrangler (YJ)
- 1988 Jeep Wrangler (YJ)
- 1987 Jeep Wrangler (YJ)
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review
Crown Automotive Plastic Valve Cover Reviews
I was skeptical of ordering this valve cover after reading the reviews. I must say I couldn't find an alternative cover, so I ordered this one. It states on the one side by the bolt holes to "pry here". So even though the holes don't line up, you must pull the cover over so they will. After a couple adjustments of tightening the bolts, there are no leaks. I did have to put a rubber gasket on the oil cap to make it tight. Other than that, it works fine.
Worked as intended and fit no problem in my 89 YJ
Junk. This is why Chinese manufacturing gets a bad name. The valve cover is out of spec in multiple places, and would require heading and bending the sidewalls to align with the threaded holes in the head. The new grommets, and the old grommets would not sit securely in their respective holes as the thickness of the valve cover was too thin to hole them securely. I will not be ordering from Crown again.
Questions
