Reviews for Quadratec Pre-Runner LED Light Kit for 18-25 Jeep Wrangler JL & Gladiator JT
Works awesome!
Looks great! Seems well made, time will tell. Installation was pretty much spot on as per the instructions with the possible exception of getting to the connector. I don’t know if every model is the same, but on my Overland, it is directly across from what I think is the ABS controller, tucked up just inside the wheel well. They have it secured to the body using a slide lock. Problem is it is very tight, with electrics, washer plumbing, the inner fender, and the shape of the sheet metal at that point. No way could I get my hand in there to release it and pull it through into the engine compartment to separate it and then attach the Quadratec connectors for the lights. At least, I couldn’t do it so I had to drop the inner fender, not hard, just takes more time, and I had never done it before so I did not know what to expect. Plus, I had to go to HF to pick up a Poly Rivet tool to reattach the inner fender back to the fender flares, plus a few of the nylon push in retainers from Advance Auto. The supplied rivets that came with the riveter worked OK, not quite as pretty as the OEM but no one will notice but me. All in all, for any one who is familiar with the inside of the wheel well, this job would take an hour, if that. Good luck! Hope this helps.
Waited a long time for this to finally arrive. I weighed between other options but this was worth the wait. It can be achieved without partially removing the fender well for the plug. Going through the engine bay will take a little time and patience but all and all was 30 minutes for the install. Thanks quadratec
excellent fit and looks good. easy installation
Easy to install. Makes a huge difference to the appearance of the Jeep. Definitely worth the price.
The fender liner has to be pulled loose and down to access the wiring harness connector. It's toward the passenger compartment and not near the turn signal lamp. Install time was about 2 hrs. You'll need to learn how to unbolt and unfasten the fender liner anyway to change a turn signal or side marker lamp. Be patient with the front grill cover if it is the first time removing it.
Great lighting addition to JL(U) Wrangler. Install is a bit tricky to get to the plug, but inserting into the grill is pretty easy. However when installed it looks amazing and worth all the effort.
Tonight we added the Quadratec Prerunner LED Light Kit. The instructions are pretty great. Took me longer to locate the correct wiring connection for the plug n play harness. Then a little grille trimming and reassembly could happen. I’m pretty happy with how it turned out.
Was a little hesitant about getting these cause I thought the horns would create interference but that wasn’t the case at all. Installation was very straightforward and took less than an hour. Take your time making the cuts to the grille. Start small,test fit,then cut as necessary. Once you pop the lights into the grommet they sit very snug. Overall very happy with them.
They look awesome and install took about 30 min. The wiring portion was a bit of a pain in the butt to route behind the headlight, but once you get a hand on it and can pull it through, there was no issue. The plug is a little tricky if you don’t feel like crawling under your Jeep to look at it, but it’s just like every other connector on these thing. Just pull the red tab and push down and it pops right out, then plug in the new harness and you’re all set. Super easy and it looks great. Very happy with this purchase.