HyLine OffRoad Rear Bumper & Tire Carrier Combo for 87-06 Jeep Wrangler YJ, TJ & Unlimited

The tire carrier installs directly to our specially designed Rear Bumper and features all of the following:

• Solid Steel Tube Construction (Thick .120” Wall 2”x3” Rectangle Steel Tubing)
• Heavy Duty 1-1/2” Solid Steel Greasable Machined Pivot Pin that is inserted through an extra thick ¼” Wall DOM Steel Tube
• Fully Adjustable Sliding Tire Mount for various width tires and wheels (No Drilling Necessary

unlike other competitor models)

• Pre-Cut Hole for mounting our 2” LED Third Brake Light
• Plastic Machined Alignment Block used to isolate any rattle noise and vibration between the Tire Carrier and the Tailgate
• Carries up to 37” Tire
• All necessary Grade 8 & Grade 5 mounting hardware included

All Tire Carriers receive a thorough zinc phosphate rinse and cleaning, then are E-Coated and Powder Coated with an easy to clean light black texture. The textured powder coat matches the texture on the stock black fender flares almost perfectly. Completely Bolt on, No Drilling Necessary.

Installation Notes

Installation Difficulty:

Level 3Advanced

Tools Needed: Ratchet, 18mm, 5/8”, 3/4”, 1/2”, 9/16”, 13mm socket, Torque wrench, 18mm, 5/8”, 11/16", 7/16”, 1/2”, 3/4” wrench, hand drill, 7/16” drill bit, T-55 Torx, 5lb hammer or vise, grease gun, lithium grease, wire cutters and safety glasses.

Installation Time: 2-3 hours

Installation
Instructions

Parts Included

Rear Bumper with 2” receiver
Tire Carrier
TJ frame tie in brackets
1/4” shims
5/8” plate “D” Ring mounts
Adjustable Tire Mount Bracket
Tailgate Bracket Plate
Pivot Pin
Plastic Alignment Blocks (Long & Short)
Brass Washers
All Hardware Necessary For Installation
Round Tube Plug
Aluminum Connector Rod
OEM Wheel Studs

Warranty

1 Year Limited Warranty.