Ten Factory MG22135 30 Spline Rear Axle Kit for 87-06 Jeep Cherokee XJ, Wrangler TJ & Unlimited with Dana 44
- Axle Model: Dana 44
- Axle Position: Rear
- Features: Chromoly
- Shipping Weight: 46lb
- Shipping Dimensions: 41in x 11in x 9in (L x W x H)
Jeep Cherokee (XJ)
- 2001 Jeep Cherokee (XJ)
- 2000 Jeep Cherokee (XJ)
- 1999 Jeep Cherokee (XJ)
- 1998 Jeep Cherokee (XJ)
- 1997 Jeep Cherokee (XJ)
- 1990 Jeep Cherokee (XJ)
- 1989 Jeep Cherokee (XJ)
- 1988 Jeep Cherokee (XJ)
- 1987 Jeep Cherokee (XJ)
Jeep Wrangler (TJ)
- 2006 Jeep Wrangler (TJ)
- 2005 Jeep Wrangler (TJ)
- 2004 Jeep Wrangler (TJ)
- 2003 Jeep Wrangler (TJ)
- 2002 Jeep Wrangler (TJ)
- 2001 Jeep Wrangler (TJ)
- 2000 Jeep Wrangler (TJ)
- 1999 Jeep Wrangler (TJ)
- 1998 Jeep Wrangler (TJ)
- 1997 Jeep Wrangler (TJ)
Jeep Wrangler Unlimited (LJ)
- 2006 Jeep Wrangler Unlimited (LJ)
- 2005 Jeep Wrangler Unlimited (LJ)
- 2004 Jeep Wrangler Unlimited (LJ)
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review
Ten Factory 30 Spline Rear Axle Kit Reviews
They look great, all the parts fit easily, the studs are long enough for a disk conversion. I'm happy
I got these to upgrade when my axle seals began to leak. Just like Mike F. said, you will need longer studs and you will need retaining plates. Other then that these are great, just keep in mind that the passenger side gets the longer axle shaft.
Can't speak for the strength yet as these were just installed, but 3 stars four two reason. #1, retaining plate is no included. I knew this one going into it and ordered the Crown retaining plates when I placed the order. #2 the studs are too short. This I did not catch until everything was assembled, done, and putting wheels back on. My limited research shows 2003 it looks like Jeep started using longer studs and on my 2005 Rubicon that was definitely the case...
Questions
